Montarbo E616A Instruction Manual page 48

1 2
3
1 2
3
tip ring sleeve
(GND)
tip sleeve
(GND)
48
ENGLISH
• If the mixer has XLR balanced outputs: use standard balanced XLR
connectors.
• If the mixer has XLR unbalanced outputs: in this case, unless using
a Montarbo mixer, make sure that the XLR outputs on the mixer are
unbalanced to IEC 268 standard 1 = GND, 2 = HOT, 3 = GND.
• If the mixer has JACK balanced outputs (stereo jacks):
it is possible to use stereo jack-XLR adapters, wired according to IEC 268
pin 1 = ground (sleeve), pin 2 = tip, pin 3 = ring.
• If the mixer has JACK unbalanced outputs (mono jacks):
use suitable Jack-XLR male adapters unbalanced according to IEC 268
pin 1 = ground, pin 2 = tip, pin 3 = ground.
• Connection to a sub-woofer:
- If it has a balanced input: use a balanced XLR cable like the one of the
first example.
- If it has an unbalanced input (with a female XLR connector), use a cable
like the one in the second example.
- If it as a balanced input (with a stereo jack) use a cable wired like the
one in the third example, but with a female XLR connector.
- If it has an unbalanced input (with a mono jack) use a cable wired like
the one in the fourth example, but with a female XLR connector.
1
2 1
2
3
3
1
2 1
2
3
3
tip
2 1
ring
3
sleeve
(GND)
tip
2
1
3
sleeve
(GND)
1
2
3
1
2
3
1
2
3
1
2
3