HP ProLiant MicroServer Gen8 Maintenance And Service Manual page 43

To remove the component:
Power down the server (on page 24).
1.
Disconnect the power cord from the AC source.
2.
Disconnect the power cord from the server.
3.
Open the front bezel (on page 25).
4.
Remove all drives ("LFF non-hot-plug
5.
31).
If the chassis cover was not removed in step 4, remove it
6.
Open the left and right side chassis cable clips to allow the drive cable removal.
7.
Right side cable clip
o
Left side cable clip
o
Disconnect the drive power cable:
8.
If installed, remove the optical drive
a.
drive" on page 32) and drive carriers
("Remove the chassis
("Optical drive" on page 34).
("Drive carrier" on page
cover" on page 27).
Removal and replacement procedures 43