Table of Contents
Advertisement
Cleaning and maintenance
en
Saturation display
When the metal grease filters or the activated charcoal
filter are/is saturated, an audible signal sounds for
approximately four seconds after the fan is switched off.
In addition, the corresponding symbol appears on the
display:
Metal grease filter:
!
■
Activated charcoal filter:
■
If you have not yet done so, the metal grease filters
should be cleaned or the activated charcoal filter
changed.
For instructions on how to clean the metal grease filters,
please refer to the section
The saturation indicators can be reset while they are
flashing. To do this, touch the - symbol.
Switching over the indicator for circulating-air mode
For circulating-air mode, the electronic control must be
switched over accordingly:
The extractor hood must be connected and switched
■
off.
Touch and hold the
#
■
same time, until the
™"
circulating-air mode "Starter Set". Repeatedly
pressing and holding this button combination
causes the
indicator to light up for the
'"
"CleanAir" circulating-air module.
Repeatedly pressing and holding this button
■
combination switches the electronic control back
over to ducted operation (
Audible signal
Switching on the audible signal
When the fan is switched off, press and hold the
+ symbols simultaneously for approximately three
seconds. An audible signal sounds as an
acknowledgement.
Switching off the audible signal
Repeat the "Switching on the audible signal" process.
8
"
.
Cleaning and maintenance
and
symbols at the
!
indicator lights up for
indicator).
!
#
2Cleaning and maintenance
:
Warning
t e n a n c e
C l e a n i n g a n d m a i n
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
:
Warning
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
:
Warning
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
Observe the information in the table to ensure that the
different surfaces are not damaged by using the wrong
type of cleaning agent. Do not use
harsh or abrasive cleaning agents,
■
cleaning agents with a high concentration of alcohol,
■
hard scouring pads or sponges,
■
high-pressure cleaners or steam cleaners.
■
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
and
cleaning agents.
Hide quick links:
Advertisement
Table of Contents
