Siemens LI67SA670 Instructions For Installation And Use Manual page 18

Appliance width 90 cm:
You must also screw the appliance to the wall-hanging
cupboards either side of it.
Changing the filter pull-out's limit stop
On some versions of the appliance, the limit stop for the
filter pull-out can be changed. Spacers are included
with these appliances in order to position the
appliance's handle strip flush with the fitted unit.
Pull the filter pull-out towards you.
1.
Shorten the spacer to the required dimension and
2.
insert it into the slot specified.
Connecting the pipes
If an aluminium pipe is used, smooth the area
Note:
where it is to be connected before you connect it.
Exhaust air pipe, dia. 150 mm (recommended size)
Fit the exhaust air pipe directly to the air-pipe connector
and seal the joint.
Exhaust air pipe, dia. 120 mm
Fit the reducing connector directly to the air-pipe
1.
connector.
Attach the exhaust air pipe to the reducing
2.
connector.
Seal both joints appropriately.
3.
Removing the appliance
Disconnect the electrical connection.
1.
Disconnect the pipes.
2.
Remove the metal grease filter.
3.
Remove the protective caps from the fastening
4.
elements.
Remove the appliance; see section entitled
5.
"Removing the appliance".
Installation en
17