Siemens LI67SA670 Instructions For Installation And Use Manual page 16

Body wall thickness: 16 mm
Screw the mounting pieces to the body on the left
1.
and right.
¨
Remove the tabs from the bottom of the mounting
2.
pieces.
©
Body wall thickness: 19 mm
Fold out the tabs on both of the mounting pieces.
1.
Screw the mounting pieces to the body on the left
2.
and right.
©
Remove the tabs from the bottom of the mounting
3.
pieces.
ª
Preparing the appliance
Connect the power cord provided to the appliance.
5Installation
Sliding the appliance up into place
I n s t a l l a t i o n
Slide the appliance up into place and make sure it is
1.
positioned correctly.
Measure the distance between the appliance and
2.
the wall, and mark this on the filler strip.
If required, shorten the filler strip to the required
3.
dimension.
©
¨
Sliding out the appliance
Before you remove the appliance, protect the hob
Note:
with a piece of polystyrene from the packaging.
Use a flat-blade screwdriver to push in the fastening
1.
bolt, and turn it 90° until it locks into place.
Push in the fastening bolt gently with your fingers,
2.
and turn it until it comes out of the housing along
with the spring.
When doing this, grip the bottom of the appliance
with the other hand.
Caution!
Push in the fastening bolt gently with your fingers,
and turn it until it comes out of the housing with the
spring.
Installation en
¨
¨
©
15