Olympus DIGITAL CAMERA SP-320 Advanced Manual page 160

Troubleshooting
Possible cause
Pictures you have taken do not appear on the monitor.
The power is off.
The camera is in the
shooting mode.
There are no pictures in
the internal memory or
on the card.
There is a problem with
the card.
The camera is
connected to a TV.
Single-frame erase and all-frame erase cannot be performed.
The pictures are
protected.
No picture is displayed on the TV when connected to the camera.
The video output signal
is incorrect.
The TV video signal
setting is incorrect.
The monitor is hard to see.
The brightness of the
monitor is not adjusted
properly.
The monitor is exposed
to direct sunlight.
10
160
Corrective action
Set the mode dial to a mode other than q,
and press the POWER button.
Press the QUICK VIEW button or set the
mode dial to q.
[NO PICTURE] is displayed on the monitor.
Record pictures.
See "Error messages".
The monitor does not function when the AV
cable is connected to the camera.
Cancel the protection of the pictures.
Set the video output signal according to the
region where used.
Set the TV to the video input mode.
Use [s] to adjust the brightness.
Block the sunlight with your hand.
Ref.
page
P. 22
P. 10,
76
–
P. 153
P. 99
P. 101
P. 100
–
P. 112
–