"TEMP NG"
•
The temperature protection circuit has been activated, and
the system will switch off. Let the unit cool down before
switching it on again.
•
Check that the ventilation opening of the unit is not
obstructed.
•
Ensure this unit is well ventilated.
"TRK FULL"
•
The number of files has exceeded the supported limit.
"USB OVER CURRENT ERROR"
•
The USB device is using too much power. Disconnect the
USB device, switch off the system and then switch on
again.
"VBR"
•
The system cannot show the remaining play time for
variable bit rate (VBR) tracks.
Remote control code
When other Panasonic equipment responds to the
remote control of this system, change the remote control
code for this system.
Preparation
Press [CD/RADIO/AUX] to select "AUX 1" or "AUX 2".
█
To set the code to "REMOTE 2"
1
Press and hold [CD/RADIO/AUX] on the main unit
and [2] on the remote control until "REMOTE 2" is
shown.
2
Press and hold [OK] and [2] for a minimum of
4 seconds.
█
To set the code to "REMOTE 1"
1
Press and hold [CD/RADIO/AUX] on the main unit
and [1] on the remote control until "REMOTE 1" is
shown.
2
Press and hold [OK] and [1] for a minimum of
4 seconds.
System memory reset
Reset the memory when the following situations occur:
• There is no response when buttons are pressed.
• You want to clear and reset the memory contents.
1
Disconnect the AC power supply cord.
2
While you press and hold [1] on the main unit,
connect the AC power supply cord again.
Continue to press and hold the button until
"– – – – – – – – –" is shown.
3
Release [1].
All the settings are set back to the factory preset.
It is necessary to set the memory items again.
Specifications
█
Amplifier section
RMS output power stereo mode
SC-MAX8000
500 W per channel (3 Ω), 1 kHz, 30% THD
High Ch
500 W per channel (3 Ω), 1 kHz, 30% THD
Mid Ch
Low Ch 1000 W per channel (5 Ω), 100 Hz, 30% THD
Total RMS stereo mode power
SC-MAX6000
350 W per channel (3 Ω), 1 kHz, 30% THD
Front Ch
350 W per channel (3 Ω), 1 kHz, 30% THD
Front Ch
Subwoofer Ch
Total RMS stereo mode power
SC-MAX4000
350 W per channel (3 Ω), 1 kHz, 30% THD
High Ch
350 W per channel (3 Ω), 1 kHz, 30% THD
Mid Ch
500 W per channel (2 Ω), 100 Hz, 30% THD
Low Ch
Total RMS stereo mode power
█
Disc section
Disc played (8 cm or 12 cm)
MPEG-1 Layer 3, MPEG-2 Layer 3
Pick up
Wavelength
█
Bluetooth
section
®
Version
Class
Supported profiles
Operating frequency
Operation distance
█
Internal memory section
Memory
Memory size
Media file format support
Memory recording
Bit rate
Memory recording speed
Recording file format
725 W per channel (6 Ω), 100 Hz,
30% THD
CD, CD-R/RW (CD-DA, MP3 )
790 nm (CD)
Bluetooth
Ver. 2.1 + EDR
®
A2DP, AVRCP, SPP, OPP, FTP
2.4 GHz band FH-SS
10 m line of sight
MP3 (*.mp3)
128 kbps
1x, 3x max (CD only)
MP3 (*.mp3)
4000 W
2850 W
2400 W
Class 2
2 GB
21