Taking Pictures; Turning On The Power - Olympus Camedia D-450ZOOM Instructions Manual

Slide open the lens
barrier.
.
.
.
.
.
.
Control panel
.
.
Card error
.
.
60
Push up the flash.
.
.
Viewfinder
.
.
Green lamp
.
.

TAKING PICTURES

E

TURNING ON THE POWER

To turn on the power, just slide open the lens barrier on the
front of the camera. When it is turned on, it automatically
checks the SmartMedia card. If there is a problem with the
card, the camera emits a beep sound and displays the
following:
When there is no SmartMedia card in the camera / the
card is protected...
The Card error indicator on the control panel and the Green
lamp will blink.
When the card needs to be formatted...
The Card error indicator lights on the control panel, and the
camera enters the Card format mode. (p. 158)
Olympus brand cards are recommended (already
formatted). Non-Olympus brand cards must be formatted
by the camera.
Note:
If you do not operate the camera for three
minutes, the camera will be set to the stand-by
mode. After four hours in the stand-by mode, the
power turns off automatically. (Time varies
depending on the type of batteries used.)
To turn on again, close and open the lens barrier.
Set the date before taking pictures. (p. 156)