Alarm Enable; Misc - Lorex SG17F6584 Instruction Manual

ALARM ENABLE

Controls when an alarm will become active (if detected) on the Observation System. Use the
SHUTTLE (JOG) to navigate to the ALARM ENABLE option, and press ENTER (press down on
the SHUTTLE) to adjust the options.
Continue pressing the ENTER (SHUTTLE) button to switch between options within the
DATE-TIME menu, and turn the SHUTTLE (JOG) to adjust the setting.
1. FROM - Sets the Start Time for alarm detection. Use the Shuttle JOG to change the time setting
for Hour and Minute.
2. TO - Sets the End Time for alarm detection. Use the Shuttle JOG to change the time setting for
Hour and Minute
To exit the ALARM ENABLE menu, press the MENU key on the front panel of the Observation
System.

MISC

Controls the Miscellaneous settings on the Observation System. Use the SHUTTLE (JOG) to
navigate to the MISC option, and press ENTER (press down on the SHUTTLE) to adjust the
options.
Continue pressing the ENTER (SHUTTLE) button to switch between options within the MISC
menu, and turn the SHUTTLE (JOG) to adjust the setting.
1. PIP LOC - Sets the PIP (Picture in Picture) onscreen location. Use the Shuttle JOG to change
the location setting to Top Left, Top Right, Bottom Left of Bottom Right.
2. SEQUENCE - Changes the SEQUENCE mode setting. Use the Shuttle JOG to change the
sequence setting to Full Screen or PIP Sequence Mode.
3. NAME DISP - Turns the Name Display ON or OFF on the Observation System. Use the Shuttle
JOG to change the setting to ON or OFF
4. AUDIO - Sets Audio to ON or OFF on the Observation System. Use the Shuttle JOG to change
the setting to ON or OFF
5. ALM BEEP - Turns the Alarm Beep ON or OFF on the Observation System. Use the Shuttle
JOG to change the setting to ON or OFF
6. ALARM OUT - Sets the Alarm OUT voltage to HIGH (5V) or LOW (0V). Use the Shuttle JOG
to change the setting to H or L.
7. ALARM RST - Sets the length of time that an Alarm will be active. Use the Shuttle JOG to
change the setting to 5, 10, 15, 20, 25, 30, 35, 40, 45, 50, 55, 60 or OFF.
To exit the MISC menu, press the MENU key on the front panel of the Observation System.
SETUP [1]
21