Looper - DigiTech vocalist live fx Owner's Manual

Looper

The Live FX's built-in mono phrase looper allows you to record a vocal loop, record
infinite overdubs on the loop, and undo/redo overdubs during live performance. The
looper is placed last in the signal chain. This allows all enabled effects to be recorded
with the loop and allows overdubs to be recording with different effects applied. The
maximum allowable loop recording length is dependent upon whether the looper
Undo function is enabled or disabled. See
information on the Loop Undo feature.
Looper Functions
To enable the Looper, press and hold the
<Down> footswitch. Once enabled, the
table at the bottom of the display will show
you which looper functions can be accessed
by pressing the corresponding footswitches,
as shown in the image to the right.
To use the looper:
1. Press and hold the <Down> footswitch for 2 seconds. "LOOPER READY"
will appear in the display and the <Down> footswitch LED will flash red,
indicating the looper is ready to begin recording.
2. Press the <Down> footswitch to start recording. The <Down> footswitch
LED will light solid red and recording will begin, indicated by a recording
progress bar in the display.
3. When you are finished recording you can perform one of three functions, they
are:
A. Stop Recording & Immediately Start Loop Playback
Press the <Down> footswitch to set the loop end point and
immediately begin loop playback. Playback is indicated by a play progress
bar in the display.
B. Stop Recording & Start Playback Manually
Press the <Up> footswitch to set the loop end point–playback will not
be initiated. When you're ready to play the loop, press the <Down>
footswitch.
C. Clear the Loop & Record it Again
If you feel the loop needs to be re-recorded, press the <Up>
footswitch two times consecutively–holding it down for about 2
seconds on the second press (the first press will stop recording and the
second press will clear the loop). Now repeat steps 2 and 3.
22
"Loop Undo" on page 34
Owner's Manual
for further
U01 PRESET 1
LOOPER READY
DOWN UP A/B
RECORD EXIT