DigiTech vocalist live fx Owner's Manual page 27

To enable/disable each Live Adapt option:
1. Press and hold the <Live Adapt> button for 2 seconds. The button will begin
flashing and the display will show the available Live Adapt options.
2. Use the corresponding <Edit> knobs to edit each option.
3. Press the <Live Adapt> button again to exit.
To globally enable/disable the Live Adapt feature:
1. Press the <Live Adapt> button. When the button is lit, the Live Adapt
feature is enabled.
NOTE: When using the Aux In jack with Live Adapt,you should audition the level
of the signal. Live Adapt will work best when this signal is strong, yet undistorted.
To do this:
• Go into the System Edit menu by pressing the <System> button.
• Press the <DATA> encoder two times to display page 3 of the System Edit
menu and temporarily set the AUX parameter to MIX (instead of MUTE) using
the <Edit 3> knob.
• You can now audition the feed to the Aux In jack. Ensure you are getting a nice
strong signal relative to the vocal and that you aren't clipping the Aux Input. If
the vocal is much louder than the guitar, adjust the sending gains accordingly.
• Once done, set the AUX parameter back to MUTE using the <Edit 3> knob.
Owner's Manual 21