3. Remove the removable battery. See "Replacing the removable battery" on page 124.
4. Remove the base cover assembly. See "Replacing the base cover assembly" on page 126.
5. Open the latches on both sides of the memory slot at the same time
module
2
.
6. Place the notched end of the new memory module toward the contact edge side of the memory slot.
Then insert the memory module
module downward until it snaps into place
the slot and cannot be moved easily.
Attention: Do not touch the contact edge of the memory module. Otherwise the memory module
might get damaged.
7. Reinstall the base cover assembly. See "Replacing the base cover assembly" on page 126.
8. Reinstall the removable battery. See "Replacing the removable battery" on page 124.
9. Turn the computer over. Connect the ac power adapter and all cables.
Replacing an M.2 wireless WAN card
Note: The following information is only for the user-installable modules.
Before you start, print these instructions. Read the Important safety information first, see "Important safety
information" on page vi.
1
into the slot at an angle of about 20 degrees. Pivot the memory
2
. Ensure that the memory module is firmly installed in
1
, and then remove the memory
.
Chapter 10
Replacing devices
131