Aprilaire 8920W Owner's Manual page 5

WI-FI SETUP & REMOTE ACCESS
STEP 3 – CONNECT YOUR WI-FI THERMOSTAT TO YOUR HOME NETWORK
1.
Confirm your thermostat is in Wi-Fi setup mode . The signal indicator will be strobing:
Note: Out of the box, your Aprilaire Wi-Fi thermostat should be in Wi-Fi setup mode .
It may take up to 30 seconds for the thermostat to enter Wi-Fi setup mode after
power up or reset . If you are not in this mode, refer to page 35 to clear your router
settings and enable Wi-Fi setup mode . O pen the app and select
thermostat .
2.
Follow the directions for your operating system (as noted below), then proceed to #4 .
Android Users:
• A list with available thermostats
will appear on the screen . Tap to
select the thermostat you wish to
connect to your network .
• For identification the SSID
contains the model number and
the last six digits of the MAC ID .
Ex . APRILAIRE8620W000000
1
3
iOS Users:
• Follow the directions on the screen:
• Exit the app .
Connect a new
• Enter Wi-Fi in the settings menu .
• A Wi-Fi network including
"APRILAIRE" in the title should
appear in your list of network options .
Tap that network (thermostat) to
proceed . Note: This step may take up
to one minute to complete .
• Return to the app .
5
2