Canon MVX460 Instruction Manual page 95

Audio dubbing will stop if the tape has a blank section or a section recorded in
LP mode or 16-bit mode.
You cannot use the DV terminal for audio dubbing.
The sound quality of the audio dubbed will deteriorate when you audio dub a
tape that was recorded with a different camcorder or when you audio dub the
same tape more than 3 times.
You can check the picture on the LCD screen.
audio on the camcorder's speaker.
Set the zero set memory at the end of the scene you wish to audio dub. The
camcorder will automatically stop audio dubbing at that point.
Playing Back the Added Sound
You can select to play back Stereo 1 (original sound), Stereo 2 (dubbed audio), or adjust
the balance of both sounds.
Available only in the
MENU
( 63)
1. Open the FUNC. menu, select (
2. Select (
( ) the [12bit AUDIO] option and press (
3. Select a setting option and press (
• STEREO1: Plays back the original sound.
• STEREO2: Plays back the added sound.
• MIX/FIXED: Plays back Stereo 1 and Stereo 2 at the same level.
• MIX/VAR.: Plays back Stereo 1 and Stereo 2. The mix balance can be adjusted.
• If you select an audio setting other than [MIX/VAR.], close the menu.
To adjust the mix level when you select [MIX/VAR.]:
4. From the [AUDIO SETUP] menu select (
option and press (
5. Adjust (
save the changes, then close the menu.
The camcorder resets to [STEREO1] when you turn the camcorder off. However,
the mix balance is memorized by the camcorder.
Downloaded From VideoCamera-Manual.com Manuals
If you use [AUDIO IN] for the dubbing, you can check the
mode.
AUDIO SETUP
) the [AUDIO SETUP] menu and press (
).
) the mix level between ST-1 and ST-2 and press (
12bit AUDIO STEREO1
) the icon and press (
).
) to save the changes.
) the [MIX BALANCE]
).
). Then, select
) to
E
95