Broan allure QS3 series User Manual page 3

PREPARE THE HOOD
TEFLON ® -
COATED
BOTTOM
COVER
(Held in
place with
2 screws)
®
3 Remove Teflon -coated bottom cover from hood. Set
cover and mounting screws aside.
®
Teflon is a registered trademark of DuPont.
4 Remove Damper/Duct Connector from inside the hood.
Set connector aside - with mounting screws and parts bag.
5 Remove either top or back wiring knockout and install
approved Electrical Cable Clamp.
®
(Continued)
DAMPER/
DUCT
CONNECTOR
ELECTRICAL
CABLE CLAMP
PREPARE THE HOOD
NOTE If hood is to be installed Non-Ducted:
•
Purchase a set of (2) Non-Ducted Filters from your
local distributor or retailer and attach them to the
aluminum mesh filters.
•
Skip to "CONNECT WIRING" section on page 4.
TOP RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Vertical & for 7" Round
Discharge)
REAR
RECTANGULAR
DUCT KNOCKOUT
(Remove for 3¼" x 10"
Horizontal Discharge)
6 Remove appropriate Duct Knockout(s) from top or back of
hood.
TIES
SCREW
METAL STRIP
PLATE
7 Horizontal Discharge Only: Remove the Plate in front of the
horizontal discharge knockout. Cut the Ties, lift plate out, and
discard plate. DO NOT REMOVE the Metal Strip held in place
with two Screws.
®
ALLURE QS3 SERIES
RANGE HOOD
Page 3
(Continued)
SEMI-CIRCULAR
DUCT KNOCKOUT
(Remove for 7" Round
Discharge)