Machine Screw M4 X 15 (Black) - Hitachi UR 18DSL2 Service Manual

Cordless radio

Hide thumbs Also See for UR 18DSL2:

(2) Remove the five Machine Screws (W/Flange) M2.6 x 10 (Black) [19]. Then you can remove the

Controller PCBA [17]. (Fig. 6)

Fig. 6 • Controller PCBA [17] at the top of the front housing

<<Reassembly>>

Reverse the disassembly procedure. Note the following at reassembly:

(1) Do not forget to attach the Fibre Washers [18].

(2) Be careful to prevent dust or fingerprints from adhering to the LCD monitor on Controller PCBA [17] and

the transparent window of the Front Housing Ass'y [8].

4. Disassembly and reassembly of the external device storage case

Detaching the USB PCBA

<<Disassembly>>

(1) Remove the four Machine Screws M4 x 15 (Black) [3].

(2) Next, remove one Machine Screw M4 x 15 (Black) [3] on the handle arm cover side.

(3) Remove the two Flange Screws D3 x 6 [60] on the back of the box plate.

(4) Cut off the wire ties and then remove the connector and the magnet.

<<Reassembly>>

Reverse the disassembly procedure. Note the following at reassembly:

(1) Be careful not to allow the internal wires to get pinched.

Fig. 7 • Detaching the USB PCBA

• Four Machine Screws M4 x 15 (Black) [3]

• Two Flange Screws D3 x 6 [60]

Five Machine Screws (W/Flange)

M2.6 x 10 (Black) [19]

• One Machine Screw M4 x 15 (Black) [3]

• Lower inside of back housing

-7-

Table of Contents