Setting The Zoom Lever; Power Switch Operation Method - Olympus PT-019 Instruction Manual

Waterproof case

Table of Contents

Setting the Zoom Lever

When loading the digital camera

in the Case, fit the projecting

part of the zoom lever of the

digital camera into the recessed

part of the zoom lever on the

inside of the Case.

CAUTION

: • When loading the camera, confirm that the projecting

part of the zoom lever of the camera is properly set to

the recessed part of the zoom lever of the Case.

• When the setting is insufficient, the loading of the

camera becomes imperfect and it may not be

possible to seal the Case or zooming may not

function. Insufficient sealing will cause water leakage.

Power switch operation is

possible by operating the

power switch lever of this

Case corresponding to the

power switch lever of the

digital camera in the Case.

Note: • When the set time (initial setting: 3 minutes) passes without

any operation while the digital camera is installed in

shooting mode, the camera enters into sleep mode (standby

status) and the operation stops.

To cancel sleep mode (return to operation status), press the

shutter button or any other button.

For details, refer to the instruction manual for the digital

camera.

E-13

Table of Contents