Advertisement
4
5
6
Remove all the parts from the front axle.
1. Slide a Ø10 washer onto the front axle.
2. Slide the bushing (ring end first) onto the front axle.
3. Slide the normal wheel (with wheel hubcap) onto the rear axle. and keep the
normal wheel match with the bushing.
4. Slide a Ø10 washer onto the front axle.
5. Tighten a Ø10 Locknut to the end of the front axle with a spanner.
6. "Snap" the hubcap to the wheel cover.
Repeat this step for the other side.
GAP
Attach the Front Wheels │ 10
After assembling any wheel to the axles, please check the gap
between the screw thread and the collapsible (refer to below picture), if
the gap is too big, please add two or three washers inside the wheel, But
after tightening the nut outside the wheel, please turn the wheel by your
finger to check if the wheel can run smoothly, this is very important,
because if the wheel can run smoothly, it is ok, but if the nut press the
wheel and the wheel can't run smoothly, the motor will be broken easily!
Then you need to decrease one or two washers to make sure the wheel
can run smoothly!
Front axle
1
2
3
Tools required: Spanner
Advertisement
