Connecting The Assembly Cable - Samsung MH026FPEA Training Manual

3-6 Connecting the Assembly Cable

3-6-1 Indoor unit
I MH026FPEA / MH035FPEA / MH052FPEA
The indoor unit is powered from the outdoor unit via the assembly cable.
1. Extend the assembly cable if necessary.
2. Open the front grille by pulling on the tabs on the lower right and left sides of the
indoor unit.
3. Remove the screw securing the connector cover.
4. Pass the assembly cable through the rear of the indoor unit and connect the
assembly cable such as figure.
- Each wire is labelled with the corresponding terminal number.
5. Pass the other end of the cable through the 65 mm hole in the wall.
6. Replace the connector cover, carefully tightening the screw.
7. Close the front grille.
8. For further details on how to plug the other end of the assembly cable into the
outdoor unit, refer to installation manual of the outdoor unit.
Samsung Electronics
Indoor
1(L) 2(N) F1 F2
unit
1 2 E
F1 F2
Earth
terminal
1 2 E
F1 F2
Outdoor
Earth
unit
terminal
F1 F2
1(L) 2(N)
29