Samsung MH026FPEA Training Manual page 29

3-5 Transmitter Installation (Optional)
3-5-1 Accessories(Transmitter)
Transmitter Transmitter power cable
3-5-2 Accessories(Outdoor Unit)
3-wire Power Cable 2-wire Assembly Cable
(option)
Flare Nuts, 9.52mm
outer pipe diameter (Nut 1/2", Bolt 3/8")
1. Fix the case with bolts on the control box in the outdoor unit.
(See the picture on the right side)
2. Attach the transmitter PCB into the case in the control box in the outdoor
unit, then connect the power and the communication cable between the
transmitter and the outdoor unit; refer to the figure below.
3. If you install a transmitter to an outdoor unit, every indoor unit which is
connected to an outdoor unit can be controlled simultaneously.
4. Each outdoor unit connected to the same centralized controller has its own
transmitter.
28
Transmitter
communication cable
Drain Plug
(option)
Flare Bolt
Installation Manual
Transmitter power cable Rubber Leg
Case Cable-tie
Flare Nuts, 6.35mm
outer pipe diameter
Transmitter
7seg. LED
Display side
Terminal
side
Bolts spec.
M4
Fix the case with bolts
(Control Box in the outdoor unit)
Samsung Electronics