Bosch GCM 12 GDL Professional Original Instructions Manual page 33

OBJ_BUCH-1360-003.book Page 33 Wednesday, November 11, 2015 2:13 PM
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains
socket elsewhere.
Products sold in AUS and NZ only: Use a residual current
device (RCD) with a rated residual current of 30 mA or
less.
Symbols
The following symbols can be important for the operation of
your power tool. Please memorise the symbols and their
meanings. The correct interpretation of the symbols helps
you operate the power tool better and more secure.
Symbols and their meaning
 Laser Radiation
Do not stare into beam
Class 2 laser product
 Keep hands away from the cutting area
while the machine is running. Danger of
injury when coming in contact with the
saw blade.
 Wear a dust respirator.
 Wear safety goggles.
 Wear ear protectors. Exposure to noise
can cause hearing loss.
 Danger area! Keep hands, fingers or
arms away from this area.
 Keep your fingers clear of the movable
parts of the glide arm. Danger of fingers
being crushed or contused and consider-
ably injured.
30
Ø
305 mm
Ø
mm
Observe the dimensions of the saw blade. The hole diameter
must match the tool spindle without play. Do not use reduc-
ers or adapters.
Bosch Power Tools
Symbols and their meaning
When transporting the machine, hold it only
at the locations indicated (recessed han-
dles) or by the transport handle.
Never carry the power tool via the handle of
the glide arm.
Bevel lock lever open:
Adjusting bevel angles is possible.
Bevel lock lever shut:
The set bevel angle of the glide arm is locked.
Indicates the individual steps for adjusting the bevel angle.
1. Loosen lock lever
2. Tilt the glide arm lightly leftward
3. Set the desired bevel angle range on the rotary knob
Setting bevel angle ranges on the rotary knob
Saw blade is inclined to the left (45° to 0°)
Saw blade is inclined to the right (0° to 45°)
Total tilting range of the glide arm (–47° to +47°)
English | 33
1 609 92A 285 | (11.11.15)