Specifications - Makita KP312 Instruction Manual

ENGLISH (Original instructions)
1-1. Knob
1-2. Scale plate
2-1. Switch trigger
2-2. Lock button / Lock-off button
2-3. Restart button
3-1. Pins
3-2. Edge fence (Guide rule)
4-1. Rear base
4-2. Foot
4-3. Planer blade
5-1. Front base
6-1. Hex wrench
6-2. Installation bolt
7-1. Hex wrench

SPECIFICATIONS

No load speed (min
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
For European countries only
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Wear ear protection
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : planing softwood
Vibration emission (a
Uncertainty (K) : 1.5 m/s
Explanation of general view
8-1. Drum plate
8-2. Installation bolt
8-3. Set plate screw
8-4. Set plate
8-5. Planer blade
8-6. Adjusting screw
8-7. Drum
10-1. Drum plate
10-2. Installation bolt
10-3. Set plate screw
10-4. Set plate
10-5. Planer blade
10-6. Adjusting screw
10-7. Drum
Model
Planing width
Planing depth
-1
)
Overall length
Net weight
Safety class
) : 92 dB(A)
pA
) : 103 dB(A)
WA
2
) : 2.5 m/s
h
2
KP312
ENE001-1
The declared vibration emission value has been
•
measured in accordance with the standard test
ENF002-2
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
WARNING:
The vibration emission during actual use of the
•
ENG102-2
power tool can differ from the declared emission
value depending on the ways in which the tool is
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG222-2
4
11-1. Hex wrench
11-2. Wrench holder
11-3. Rear base
12-1. Chip guide
13-1. Joint
13-2. Nozzle assembly
14-1. At the start of planing
14-2. At the end of planing
15-1. Front roller
16-1. Limit mark
17-1. Screwdriver
17-2. Brush holder cap
KP312S
312 mm
0 - 3.5 mm
12,000
551 mm
18.4 kg
/II
ENG901-1