Specifications; Planer Safety Warnings - Makita KP0800 Instruction Manual

ENGLISH (Original instructions)
1. Pointer
2. Knob
3. Lock button or Lock-off button
4. Switch trigger
5. Planer blade
6. Rear base
7. Foot
8. Socket wrench
9. Bolt
10. Drum
11. Drum cover
12. Adjusting plate
13. Inside edge of gauge plate
14. Blade edge
15. Screws
16. Heel

SPECIFICATIONS

Planing width
Planing depth
Shiplapping depth
No load speed (min
Overall length
• Due to our continuing programme of research and development, the specifications herein are subject to change without
notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Intended use
The tool is intended for planing wood.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
General Power Tool Safety
Warnings
WARNING Read all safety warnings and all
instructions. Failure to follow the warnings and
instructions may result in electric shock, fire and/or
serious injury.
Save all warnings and
instructions for future reference.
6
Explanation of general view
17. Back side of gauge base
18. Gauge plate
19. Gauge base
20. Pan head screw
21. Planer blade locating lugs
22. Heel of adjusting plate
23. Set plate
24. Inside flank of Gauge base
25. Mini planer blade
26. Groove
27. Hex. flange head bolt
28. Dust bag
29. Nozzle
30. Fastener
31. Elbow
32. Start
Model
-1
)
Net weight
Safety class

PLANER SAFETY WARNINGS

ENE001-1
ENF002-2 1. Wait for the cutter to stop before setting the tool
down. An exposed cutter may engage the surface
leading to possible loss of control and serious injury.
2. Hold the power tool by insulated gripping surfaces
only, because the cutter may contact its own cord.
Cutting a "live" wire may make exposed metal parts of
the power tool "live" and could give the operator an
electric shock.
3. Use clamps or another practical way to secure and
GEA010-1
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it
unstable and may lead to loss of control.
4. Rags, cloth, cord, string and the like should never
be left around the work area.
5. Avoid cutting nails. Inspect for and remove all
nails from the workpiece before operation.
6. Use only sharp blades. Handle the blades very
carefully.
7. Be sure the blade installation bolts are securely
tightened before operation.
8. Hold the tool firmly with both hands.
9. Keep hands away from rotating parts.
33. End
34. Cutting line
35. Screw
36. Edge fence (Accessory)
37. Sharpening holder
38. Wing nut
39. Blade (A)
40. Blade (B)
41. Side (D)
42. Side (C)
43. Limit mark
44. Chip cover
45. Screwdriver
46. Brush holder cap
KP0800
82 mm
2.5 mm
9 mm
17,000
285 mm
2.6 kg
/II
GEB010-4