Wiring Requirements - Heatilator NBV3630I-B Installation Manual

B. Wiring Requirements
Intellifi re Ignition System Wiring
• Wire the appliance junction box to 110-120 VAC for
proper operation of the appliance.
WARNING! Risk of Shock or Explosion! DO NOT wire
IPI controlled appliance junction box to a switched circuit.
Incorrect wiring will override IPI safety lockout.
• Refer to Figure 9.2, Intellifi re Pilot Ignition (IPI) Wiring
Diagram.
• This appliance is equipped with an Intellifi re control valve
which operates on a 3 volt system.
• Plug the 3 volt AC transformer into the appliance junction
box to supply power to the unit OR install two D cell
batteries (not included) into the battery pack before use.
NOTICE: Batteries should not be placed in the battery
pack while using the transformer. Remove batteries before
using the transformer, and unplug the transformer before
installing the batteries. Battery polarity must be correct or
module damage will occur.
Optional SPST
Wall Switch
OR
Optional Remote
GRN*
WHT
* GRN wire only used with
optional wall switch
WSK-MLT-HTL
Figure 9.2 Intellifi re Pilot Ignition (IPI) Wiring Diagram
Heatilator • NBV3630I-B, NBV3933I-B, NBV4236I-B, NBV4842I-B Installation Manual • 2376-980 Rev. F • 7/16
Battery
Pack
- +
-
+
Limit
Switch
3V
Adaptor
BLK
BLK
BLU
RED
Control
Box
To
Junction
ORG
Box
WHT
RED
BLK
BRN
ORG
GRN
Valve
Pilot Assembly
Flame
Igniter
Sensor
25