_______________________________________________________________________________________________ - Microplex SOLID F40 Operator's Manual

12 Introduction

_______________________________________________________________________________________________

_______________________________________________________________________________________________
MICROPLEX
- Do not bridge a safety device.
- Do not push anything into the ventilation apertures.
- Never perform installations, cleanings or maintenance work that is
not described in this manual. Such work should only be done by
MICROPLEX authorized service personnel.
- To avoid damage, the devices must be switched off (i.e. cut off
from the power supply) before the user begins connecting the
interface line.
In case of emergency, in order to disconnect the printer from the
main power, please note the following:
- For connected printers with plugs, an easily accessible power-
outlet should be installed near the printer.
- For permanently connected printers, an easily accessible
emergency power-off switch should be installed close to the
printer.
- Please do not conceal any disconnect devices with the printer
or other objects.
- After switching off the device, wait at least 15 seconds before
restarting the printer.
- Please follow all the information and hints directly attached to
the device and/or described in this manual.
Operator's Manual SOLID F40 Edition 1.1