3
Install the Toner
Unwrap the toner
cartridge.
Shake it
back and forth.
4
Make Connections
!
For more information, see "Interfacing with the Computer" under Printer Controls in the on-line User's
Guide.
Power Connection
Plug in the power cord.
Network Connection (Network models Only):
1
Pigtail (supplied with network models):
Attach to the OkiLAN port (2) and to the printer's parallel
port (3) .
Note! Do not connect to the printer's serial port.
4
Ethernet Cable, not supplied
PC: Requires Ethernet cable with two twisted wire pairs and an
RJ45 plug.
Macintosh: Requires Ethernet crossover cable with RJ45
connectors at either end.
("Type 7," OKI P/N 40468801)
1
Remove the tape.
Place the black end under the
tab (1), then lower the gray
end into the toner well.
Close the cover.
Parallel Port (LPT) Connection
(Non-Network Models)
Requires a bidirectional parallel printer cable marked
IEEE 1284-compliant; the cable is not supplied.
4
Push the lock lever toward
the back of the printer as far
as it will go.
3
2
1
Serial Port
3