Panasonic FV-05-11VKS1 Installation Instructions Manual page 9

INSTALLATION (NEW CONSTRUCTION) CONTINUED
7. Refer to wiring diagram on page 5.
Follow all the local electrical safety codes as
well as the National Electrical Code (NEC).
Using UL approved wire nuts, connect house
power wires to ventilating fan wires. (Fig.5)
CAUTION
Mount junction box cover carefully so
that lead wires are not pinched.
8. Insert fan body and slide into adapter assy
with some strength, untill the flange overlaps
the Flex-Z Fast TM bracket. Secure the fan body to
Flex-Z Fast TM bracket by using 2 self-drilling screws,
plug connector to receptacle and secure the fan
body to adaptor by using machine screw (M4X6).
(Fig.6)
CAUTION
Secure machine screw (M4X6) to the suitable
hole and not touch the Flex-Z Fast
Please fix the screw carefully to avoid screw
slip teeth.
9. Finish ceiling work. Ceiling hole should be aligned
with the inside edge of the flange. (Fig.7)
10. Remove the tapes from louver and springs
before installation. (Fig.8)
IMPORTANT:
Replace the sensor cover before the installation
(only for plug-in Motion sensor modular FV-MSVK1).
As shown below:
Keep on pressing the clasps when removing the ornamental cover.
Ornamental
cover
Insert the sensor cover (attachment for FV-MSVK1) into slot.
Sensor
cover
11. Insert the grille mounting spring on the wiring
side into the slot. (Fig.9)
12. Plug in the specified devices as your choice
(refer to installation on page 8). Insert the
motion sensor (FV-MSVK1 only) or LED night
light (FV-NLVK1 only) into slot of the grille.
Fix the lead wire into the clasp
Conduit
Junction
box
TM bracket.
Gloves
(Fig.9).
Earth ground
Live
Netural Earth ground
Two red wires (Connect to a
general manual wall switch)
Joist
Plug connector
Machine
screw
(M4X6)
2 Self-drilling
Receptacle
screws
Ceiling
After finishing the ceiling job, fill gap between flange
and ceillng with caulk or other sealant to prevent air
leakage
Tapes
Ceiling
Motion sensor
(FV-MSVK1 only)
WHITE
BLACK
RED
GREEN
Wire nuts
Switch box
L
N 120 VAC
LINE IN
Fig.5
Fig.6
Unit: inches (mm)
Fig.7
Fig.8
Clasp
LED night light
(FV-NLVK1 only)
Fig.9
9