Offset Mode; Staple Mode - Konica Minolta bizhub C250 Service Manual

5. Operation
5.2.6

Offset mode

• In the Offset Mode, Paper is taken back onto the Finishing Tray and shifted to the front or rear side
with the Aligning Plate. Then, a stack of paper per set is fed out onto the 1st Paper Exit Tray.
• However, even if printing has not been completed for all sets of prints, when 10 sheets for the large
size whose length is longer than 300mm or 30 sheets for the small size whose length is shorter than
299mm are stacked, a set of sheets is fed out onto the 1st Paper Exit Tray.
Paper Stacking for 4 sets in Sort Mode
3rd set
1st set
Paper Transport
Finishing Tray
5.2.7

Staple Mode

• In the Staple Mode, when one complete set of prints is fed out onto the Finishing Tray,
stapling is performed. A stack of stapled paper is then fed out onto the 1st Paper Exit
Tray.
Paper Transport
Finishing Tray
14
4583M607AA
4583M609AA
Shifted with the Aligning Plate for each job
4583M610AA
Stapling for one set of prints
Theory of Operation Ver. 1.0 Jul. 2005
Fed out onto the 1st Paper Exit Tray
4th set
2nd set
1st Paper Exit Tray
4583M608AA
1st Paper Exit Tray
4583M611AA