Installing Your Phone; Connect The Corded Handset; Connect The Power And Telephone Cords - Uniden SSE33 Owner's Manual

Hide thumbs Also See for SSE33:

Table of Contents

Use the coiled cord to connect the corded handset to the connector on the left

side of the base.

1. Connect the base AC adaptor to the DC 9V/300 mA power jack and the

telephone cord to the TEL LINE jack.

2. Plug the other end to a standard 240 V AC outlet. For safety reasons, please

only use the adaptor which is supplied with the telephone.

# If there is a power failure, you can still make and receive phone calls using

the base corded handset. All other features of the base will not function.

test the Connection

Pick up the corded handset from the base. You should hear a dial tone and the

display on the base should show 00-00. When you get a dial tone, make a quick

test call.

Installing Batteries (optIonal) in the base

1. Lift and remove the battery compartment cover.

2. Insert four AAA batteries (not supplied) into the compartment as indicated by

the polarity symbols.

3. Snap the battery compartment cover back into place.

# You can install 4 AAA Alkaline batteries in the base. The battery back up

system will then be able to power the unit for up to 12 hours if there is a

power failure. If the main power has been turned off for an extended period

or the power supply to the phone has been unplugged from main power

you should replace the batteries with 4 new high quality AAA Alkaline

batteries. Before opening the battery compartment, make sure the base is

disconnected from the telephone line and the mains power supply.

InstallIng your phone

Table of Contents