NuPrime FCC Notice - Declaration of Conformity Information This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Page 4
NuPrime WARNING: Never attempt to disassemble, repair or make any modification to your device. Disassembly, modification or any attempt at repair could cause bodily injury or property damage, as well as damage to the device itself. WARNING: Your device is not a toy. Never allow children to play with your device. Misuse, rough or improper handling of your device by children could result in serious bodily injury for any of the enumerated safety warnings in this manual.
Page 5
The IDA-8's spacious, transparent, dynamic and luxuriously textured soundstage has to be heard to be believed. With all stages in one chassis, the IDA-8 avails itself of the shortest possible signal paths in order to facilitate vanishingly low levels of noise and distortion for a black-velvet background to music. The listener’s initial reaction might very well be “I can’t believe my ears!”...
Page 6
NuPrime By utilizing discrete components in NuPrime’s ULCAM circuit, the signal can be fine tuned to reduce noise and provide maximum power. The NuPrime amp circuit improves on traditional class-D design by using a self-oscillating circuit to generate pulse-width modulation. The amplifier switches at a frequency of 600kHz, well beyond the compact disc’s 44.1kHz sampling rate.
Ultra-Linear Class A Module (ULCAM) achieves audiophile-quality sound with Class-D’s dynamics, speed and efficiency. Extraordinary result of THD+N lower than 0.0015% and S/N ratio of -130dB from ULCAM preamp stage. • NuPrime SRC IC chip provides FPGA processing with ultra-low jitter and distortion • NuPrime vibration-free isolation feet (patent pending*) •...
Page 8
NuPrime Quick Start Guide Front Panel View: Power and Input Selector: Left knob: Briefly press for 3 sec to On/Off standby mode Turn the knob to switch between inputs Volumes: Right Knob: Brief press to Mute/Unmute Turn the knob to adjust volume...
Page 9
All IDA-8s are shipped with the switch set to 230V AC in order to prevent accidental damage. Turn ON the AC power switch at the rear of the unit. The IDA-8 will now be in standby mode. Red LED indicator lights up on the front panel.
Page 10
A5: Analog input selection To run the NuPrime IDA-8 on Mac– PCM: 1. Power on NuPrime IDA-8, select USB input. The device will enumerate as a USB Audio device on your Mac. 2. In Audio Midi Setup, select the “NuPrime IDA-8” device as your default Input and Output device.
Page 11
2. Connect computer to USB DAC and power on NuPrime IDA-8, select USB DAC input. The device will enumerate as a USB Audio device on your PC. 3. Install the latest driver just download via NuPrime website.
Page 12
NuPrime 5. Configure the ASIO output a. Go to Playback->Output->ASIO, double-click on foo_dsd_asio b. Select the NuPrime ASIO Driver c. Select ASIO Native d. Select PCM to DSD Method: None e. Select Fs: DSD128 6. Configure the SACD plugin to play DSD (and not convert from DSD to PCM) a.
Page 13
OBTAINING WARRANTY SERVICE If you purchased the product in the U.S., deliver the product, at your expense, to any NuPrime Service Center located in the U.S. If you purchased the product outside of the U.S., deliver the product to any NuPrime Authorized Importer in the country where you purchased the product.
Page 14
WARRANTIES UNDER THIS LIMITED WARRANTY, ALL SUCH WARRANTIES, INCLUDING WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURATION TO THE DURATION OF THIS WARRANTY. No NuPrime reseller, agent, or employee is authorized to make any modification, extension, or addition to this warranty.
Need help?
Do you have a question about the ida-8 and is the answer not in the manual?
Questions and answers