Oki B930 Setup Manual page 6

Finish the Optional Tabloid Tray
or Tandem Tray Installation
If you purchased the optional tabloid tray or
tandem tray and mounted the printer on it earlier
in the installation, you now need to complete the
installation.
1. Make sure the printer is turned off.
1. Open each drawer, remove the packing
materials, and close the drawer.
- Tabloid Tray
- Tandem, Tray
2
3
1
2. Remove drawer 3 from the printer. Insert the
two locking screws and turn them clockwise to
secure the tray to the printer.
3. Push the drawer back into the printer.
4. Remove the interface access cover (1) from
the back of the printer, connect the tray
2
1
interface connector (2) and replace the
interface access cover (3).
5. Level the unit.
Install the Optional Duplexer
1. Make sure the printer is turned off.
2. Unpack the duplexer (duplex unit [1] and exit
module [2]) and remove cushioning materials.
3. Pull the release button to open the front cover.
6