Table of Contents
Advertisement
in the deletion of the former configuration. Instructions on firmware
uploads via the serial configuration interface are available in the LCOS
reference manual.
Boot only: A press of the button prompts a restart, regardless of how
long the it is held down.
Reset-or-boot (standard setting): Press the button briefly to restart
the device. Pressing the button for 5 seconds or longer restarts the
device and resets the configuration to its factory settings. All LEDs on
the device light up continuously. Once the switch is released the
device will restart with the restored factory settings.
This hard reset causes the device to start with the default factory set-
tings; all previous settings are lost!
Note that resetting the device leads to a loss on the WLAN encryption
settings within the device and that the default WEP key is active
again.
´
Connector for the IEC cable (LANCOM WLC-4025) or power supply unit
(LANCOM WLC-4006)
²
Power switch
¶
USB connector (LANCOM WLC-4006 only)
2.3.4
Hardware installation
Installation of the LANCOM Router involves the following steps:
LAN – First of all connect your LANCOM WLAN Controller to the LAN.
Plug in one end of the supplied network cable (green connectors) to the
uplink connector on the device
network connector socket in your local network, or a free socket on a
switch or hub.
Avoid having multiple unconfigured LANCOMs at once within a single
network segment. Any unconfigured LANCOM takes on the same IP
address (ending in '254'), and so address conflicts could arise. To
avoid problems, multiple LANCOMs should be configured one after
the other with the respective device being assigned with a new and
unique IP address (not ending in '254') each time.
LANCOM WLC-4006 - LANCOM WLC-4025
Chapter 2: Installation
·
and the other end into an available
29
Advertisement
Table of Contents
