Table of Contents
Advertisement
2.2.2
Operating access points in managed mode
LANCOM Wireless Routers and LANCOM Access Points can be operated either
as self-sufficient Access Points with their own configuration ("Access Point
mode") or as components in a WLAN infrastructure, which is controlled from
a central WLAN Controller ("managed mode").
2.3
Introducing the LANCOM WLAN Controller
This section introduces your device. We will give you an overview of all status
displays, connections and switches.
2.3.1
Status displays
The front panel of the device feature a series of light emitting diodes (LEDs)
that provide information on the status of the device.
Front side
The various LANCOM WLAN Controller models have different numbers of indi-
cators on the front panel depending on their functionality.
LANCOM WLC-4025
³·
»
¿
´
Access to the LAN via the TCP/IP protocol.
The LANtools also require a Windows operating system. A web
browser under any operating system provides access to WEBconfig.
For operation in managed mode the Access Points require firmware of
version 7.22 or higher and a current loader (version 1.86 or higher).
While the information in this section is useful for the installation of the
device, it is not absolutely essential. You may therefore skip this sec-
tion for the time being and go straight forward to 'Hardware installa-
tion'.
LANCOM WLC-4006 - LANCOM WLC-4025
Chapter 2: Installation
²
¶
ETH4
ETH3
ETH2
ETH1
Uplink
LAN
Config
21
Advertisement
Table of Contents
