Bulb Replacement - MG MG3 Owner's Handbook Manual

Bulb Replacement

Before replacing any bulb, turn off the lighting switch to
avoid any possibility of a short circuit.
Note: Only replace bulbs with the same type and
specification.
Take care NOT to touch the glass with your fingers; always
use a cloth to handle the bulb. If necessary, clean the glass
with methylated spirits to remove fingerprints.
If in doubt, when replacing bulbs, contact a specialist
workshop.
The bulb removal procedure is as follows (The installation
procedure is in reverse order, so it will not be described
here), for other bulbs not listed and to be replaced, ask an
MG Authorised Repairer for help.
EMERGENCY INFORMATION
Load Space Lamp
Insert a small flat-bladed screwdriver into the indent on
one of the narrow sides of the lens and carefully remove
the unit from its location.
6
175