MG MG3 Owner's Handbook Manual page 163

STARTING & DRIVING
figure), the indicator lamp in the instrument pack
illuminates and the cruise system is activated.
2 Press the speed set switch SET +/SET -( 2 and 4 shown
in the figure), set the memory speed of the cruise
system, and the cruise system will take effect. At this
time, the cruise control system will maintain the set
speed without depressing the accelerator pedal.Cruise
control will only operate between vehicle speeds of 25
- 125 mph (40 - 200 km/h).
Note: The set speed held in the cruise control memory
will be cancelled when either the cruise control master
switch is pressed or the ignition key removed.
Cruise control will be disengaged when the brake pedal is
pressed or a different gear is selected. To return to your
previous set speed, press the RES switch (figure 1) .
Note: The cruise control system can only work when
the gearlever is in 3rd gear or above.
Change the Set Speed
Shortly press (less than 0.5 seconds ） the SET +/SET
- switch to increase/decrease the vehicle set speed
146
in increments of 1mph/1km/h, then the vehicle will
accelerate/decelerate to the new set speed. Press and
hold the SET +/SET - switch, the vehicle will keep
accelerating/decelerating until the switch is released. The
selected speed is set accordingly.
The vehicle can also be driven using the accelerator pedal
with the cruise control activated. Once the accelerator
pedal is released, the system will return to the set speed.
When accelerating, press the SET + switch, the system will
apply the higher vehicle speed as the new set speed.