Approved PLANET SFP Transceivers
PLANET 802.3at PoE+ Switch supports both single mode and multi-mode SFP
transceivers. The following list of approved PLANET SFP transceivers is correct at
the time of publication:
Gigabit SFP Transceiver Modules
MGB-GT
MGB-SX
MGB-LX
MGB-L30
MGB-L50
MGB-L70
MGB-L120
MGB-LA10
MGB-LB10
MGB-LA20
MGB-LB20
MGB-LA40
MGB-LB40
It is recommended to use PLANET SFP on the 802.3at PoE+
Switch. If you insert an SFP transceiver that is not supported, the
802.3at PoE+ Switch will not recognize it.
Note
1. Before we connect the 802.3at PoE+ Switch to the other network device, we
have to make sure both sides of the SFP transceivers are with the same media
type, for example, 1000BASE-SX to 1000BASE-SX; 1000BASE-LX to 1000BASE-
LX.
2. Check whether the fiber-optic cable type matches with the SFP transceiver
requirement.
To connect to 1000BASE-SX SFP transceiver, please use the multi-mode fiber
cable with one side being the male duplex LC connector type.
To connect to 1000BASE-LX SFP transceiver, please use the single-mode fiber
cable with one side being the male duplex LC connector type.
SFP-Port 1000BASE-T Module
SFP-Port 1000BASE-SX mini-GBIC module - 550m
SFP-Port 1000BASE-LX mini-GBIC module - 10km
SFP-Port 1000BASE-LX mini-GBIC module - 30km
SFP-Port 1000BASE-LX mini-GBIC module - 50km
SFP-Port 1000BASE-LX mini-GBIC module - 70km
SFP-Port 1000BASE-LX mini-GBIC module - 120km
SFP-Port 1000BASE-LX (WDM, TX:1310nm) - 10km
SFP-Port 1000BASE-LX (WDM, TX:1550nm) - 10km
SFP-Port 1000BASE-LX (WDM, TX:1310nm) - 20km
SFP-Port 1000BASE-LX (WDM, TX:1550nm) - 20km
SFP-Port 1000BASE-LX (WDM, TX:1310nm) - 40km
SFP-Port 1000BASE-LX (WDM, TX:1550nm) - 40km
23