Operation
OFF
ON
OFF
OFF
58
ON
START
ZMU04599
ON
ZMU05833
2.
After stopping the engine, disconnect
the fuel line if there is a fuel joint on the
outboard motor.
3.
Tighten the air vent screw on the fuel
tank cap (if equipped).
4.
Remove the key if the boat will be left un-
attended.
TIP:
The engine can also be stopped by pulling
the cord and removing the clip from the en-
gine shut-off switch, then turning the main
switch to "
" (off).
EMU27862
Trimming outboard motor
EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
ZMU02301