Roland MC-909 Getting Started Manual page 16

®ÂØÒňΠMC-909
12. Press
looking at Measure 2.
13. Press
14. Light all of the VELOCITY PADS except 11 and 15.
15. Press
16. Press VELOCITY PADS 11 and 15 to light them.
17. Repeat Steps 8-11 to add the kick and snare. You've not got two measures recorded.
18. Press STOP to stop recording, and press PLAY if you wish to hear your work without the
metronome.
A Short Trip to the Editing Planet
Copying Recorded Measures
Let's pause in our recording session to use the MC-909's editing tools to fill up the remaining
two blank measures in our sequence.
1. Press F2 (Edit). The Pattern Edit screen appears.
2. On the Pattern Edit screen, the Source From and Source End parameters select the
portion of the sequence to be edited. Since we want to make a copy of Measures 1 and
2—the measures we just recorded—we'll set Source From to 1 for Measure 1 and Source
End to 2, for Measure 2.
©
2003 Roland Corporation U.S.
Getting Started Guide
once—the TOP POSITION readout shows that you're now
to move the note selection box back up to A#'s closed hi-hat.
twice to get to the open hi-hat.
MC-909 Getting Started Guide
Source From is already set to 1,
so press and turn the VALUE
dial to set Source To to 2,
as shown here.
Page 16