Maintenance; General; Maintenance Schedule; General Inspection - Husqvarna LB 348V Operator's Manual

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by an authorized service workshop.
Prevent unintentional starting by
removing the ignition cable from the
spark plug.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
• Let your Husqvarna dealer regularly check the
machine and make essential adjustments and repairs.
• Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
Daily Weekly

maintenance

maintenance
General inspection Spark plug

Oil level

Muffler*
Vibration

External cleaning

damping
system*
Cutting equipment
Cutting cover and
protective cover*
Engine brake
handle*
*See instructions in the section "Machine's safety
equipment".
MAINTENANCE
At least once
50 hours
a year
Replacing Replacing and
and adjusting adjusting the
the V-belt V-belt
Air filter Air filter
Fuel system Fuel system
Oil change Oil change

General inspection

• Check that nuts and screws are tight.
LC353VB
Make sure the cable clip is properly secured to the
bracket. If the cable clip feels loose or have fallen of,
mount the clip back into place.
External cleaning
• Brush leaves, grass and the like off of the lawn mower.
• Do not use a high pressure washer to clean the
machine.
• Never flush water directly on the engine.
• Clean the air intake on the starter. Check the starter
and starter cord.
• When cleaning under the cutting deck, turn the
machine with the spark plug upwards. Empty the fuel
tank.
Cleaning of the gear housing.
• Remove the service hatch.
• Brush leaves and grass off of gear housing. If
necessary clean the gear housing with water. For
LC348Ve and LC353VE make sure the battery is
disengaged.
Oil level
The lawn mower should stand on flat ground when you
check the oil level. Check the oil level with the dipstick on
the oil filler cap.
• Remove the oil cap and wipe the dipstick clean.
• Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of
the oil level.
• If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
–
English 77