Solid-State Drive Board - HP 250 G5 Maintenance And Service Manual

Solid-state drive board

Description
Solid-state drive board (includes cable)
Before removing the solid-state drive board, follow these steps:
1. Shut down the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect all external devices connected to the computer.
3. Disconnect the power from the computer by first unplugging the power cord from the AC outlet and then
unplugging the AC adapter from the computer.
4. Remove the battery (see
5. Remove the optical drive (see
6. Remove the bottom cover (see
To remove the solid-state drive board:
1. Disconnect the cable from the system board (1).
2. Remove the three Phillips PM2.0×3.0 screws (2) that secure the solid-state drive board and holder to the
computer.
3. Lift the board out of the computer (3).
4. Remove the solid-state drive from the holder (see
Reverse this procedure to install the solid-state drive board and cable.
56 Chapter 6 Removal and replacement procedures for Authorized Service Provider parts
Battery on page 38).
Optical drive on page
Bottom cover on page
39), if installed.
42).
Solid-state drive (SSD) on page
Spare part number
850946-001
55).