APPENDIX
Torque Settings - Placing in a Shield Box
SEMC Electrical Repair Manual
K800 - K810
Torque Settings K790, K800 and K810
Placing in a Shield Box
Install four M1.4 screws where in-
dicated using a torque driver set at
22 N*cm with an T6 bit.
The picture shows how to place the K800-unit in a Rohde & Schwartz Shield Box and Coupler
Install two M1.7 screws in the
locations indicated using a torque
driver set at 10 N*cm with a JCIS
No. 0 bit.
1202-3085 rev. 2
121
(121)