Connecting Peripheral Devices; Floppy And Ide Disk Drive Connectors; Serial Ata Connectors; Pci And Pci Express Slots - Nvidia N61P User Manual

nVIDIA N61P/N61S/N61V

2.5 Connecting Peripheral Devices

2.5.1 Floppy and IDE Disk Drive Connectors

The FDD connector connects up to two floppy drives with a 34-wire, 2-connector floppy
cable.Connect the single end at the longer length of ribbon cable to the FDD on the board,
the two connectors on the other end to the floppy disk drives connector. Generally you need
only one floppy disk drive in your system.
The red line on the ribbon cable must be aligned with pin-1 on both the FDD port and the floppy connector.

2.5.2 Serial ATA Connectors

Each SATA connector serves as one single channel to connect one SATA device by SATA
cable.

2.5.3 PCI and PCI Express slots

Install PCI Express X16 graphics card into slot "PCIEXP1".
Install PCI Experess X1 card into slot "PCIE". (for nVIDIA N61(V2.0) only)
Install PCI cards into slots "PCI1" and/or "PCI2".
Each of the IDE port connects up to
two IDE drives at Ultra ATA 66/100/133
mode by one 40-pin, 80-conductor,and
3-connector Ultra ATA/66 ribbon cables.
Connect the single end (blue connector)
at the longer length of ribbon cable to
the IDE port of this board, the other two
ends (gray and black connector) at the
shorter length of the ribbon cable to the
connectors of your hard drives.
Make sure to configure the "Master" and "Slave"
relation before connecting two drives by one
single ribbon cable. The red line on the ribbon
cable must be aligned with pin-1 on both the IDE
port and the hard-drive connector.
- 11 -
User's /Manual