TYT TH-UV8000E User Manual page 22

Reverse the frequency
Under standby mode, long press to turn on this function, "R" will displayed at the top
of LCD when you turn on this function. At this time, radio's transmitting frequency is its rec-
eiving one, and its receiving frequency is its transmitting one. If it is been set the CTCSS/
DCS, the code will also been exchanged.
MONI
MONI: Press and hold this key disables the noise squelching action ,allowing you to hear
very weak signals near the back-ground noise level.
FM radio
Under standby mode, press +MONI, you can input the frequency of radio or press,then
1 to search the FM, it will stop when the FM found, if you want to continue to search the FM,
press then 1. can turn off the radio by pressing the PTT, press
FM radio function.
Tone Calling(1750Tone)
To access a repeater, press and hold in "call" key for the amount of the time specified by
the repeater. The transmitter will automatically be activated, and a 1750Hz audio tone will
be superimposed on the carrier. Once access to the repeater has been gained, you may
release "Call" key and use PTT for activating the transmission.
37
Emergency Alarm
Under standby mode, press
exit.
Remote Stun/Kill and Activated
If you want to use this function, please program signaling via programming software:
Remote Stun
DTMF >Decode>-Stun Type->TX Inhibit->Stun Code
Remote Kill
DTMF >Decode->Stun Type->TX/RX Inhibit->Stun Code
A, To input stun code of radio you want to stun/kill.
B, Remote Activated: to input stun code+# to activate the stunned/killed radio.
eg. Stun code of A is 12345678, and if you want to remote kill A, please
+MONI, can exit the
use the same frequency of B, press and hold on PTT, key input 123456
78, A will be killed and if you want to activate A, please key input 12345
678+# to activate it.
C, you also can press
radio will be killed and then key input 12345678+# to activate it.
+CALL, to activate this function, until you press PTT, it will
+ , then key input 12345678, press PTT,
38