2.6.2 Serial ATA Connectors
Each SATA connector serves as one single channel to connect one SATA device by a thin SATA
cable.
The RAID 0/1/0+1/5/JBOD configuration is also possible through the combination of disk arrays
through these SATA connectors:
※ Both SATA 5 and SATA 6 are available only for models "KN9 SLI" and "KN9
Ultra".
To connect SATA device:
1. Attach either end of the signal cable to
the SATA connector on motherboard.
Attach the other end to SATA device.
2. Attach the SATA power cable to the
SATA device and connect the other end
from the power supply.
KN9 SLI, KN9 Ultra, KN9S
2-17