Advertisement
PR O B LE M
Motor will not start.
Unit does not reach
high pressure.
Output pressure varies
w.
high and lo
ENGLISH(Original Instructions)
P O SS IB LE C AU S E
On/O ff switch is in the
"OFF" (O) position.
Power cord is not plugged in.
Defective extension cable.
Electrical outlet does not supply
adequate power.
Diameter of garden hose is
too small.
Water supply is restricted.
Not enough water supply
Water inlet filter is clogged.
Power nozzle is in low-
pressure position.
Pump is sucking air.
Not enough inlet water supply.
Pump is sucking air.
Water inlet filter is clogged.
S O LU T IO N
Turn switch to the "ON"
( | ) position. Squeeze gun trigger.
Plug in power cord.
Try without extension cable.
Try a different outlet.
Replace with a 1" (25 mm) or 5/8"
(16 mm) garden hose.
Check garden hose for kinks,
leaks and blockage.
Open water source fully.
Remove filter and rinse in
warm water.
Turn power nozzle to high-
pressure position.
Check that hoses and fittings are airtight.
Turn "OFF" machine, and purge pump by
squeezing trigger gun until a steady flow
of water emerges through the nozzle.
Turn water on fully.Check garden
hose for kinks, leaks or blockage
Check that hoses and fittings are airtight.
Turn "OFF" machine, and purge pump by
squeezing trigger gun until a steady flow
of water emerges through the nozzle.
Remove filter and rinse with
warm water.
Advertisement
