Advertisement
3.
To maneuver around the repositioned Optical Assembly/Data Card
Holder, the following harnesses were lengthened:
•
DC to DC Harness (from Logic Board to DC/DC Converter Board)
- Refer to Figure 3.
•
Logic/Subject/Data Harness (from Logic Board to Subject Strobe
and Data Strobe Boards) - Refer to Figure 3.
•
Capacitor/Data Strobe Harness (from Capacitor Board to Data
Strobe Board) - Refer to Figure 5.
Camera Repair
Refer to the ID-100 Repair Manual for all repairs. All parts are the same except
for those noted in this addendum.
Important
Prior to modification of the Logic and Strobe boards, all obstructed connections
were soldered. Also, harnesses were lengthened with splices. If any of these
cameras are returned for repair, be sure to replace boards and/or harnesses
with the new parts listed on the next page.
Figure 5
5
ID-100 Manual Addendum
Capacitor/Data
Strobe Harness
(PN 70144V)
Advertisement
