Advertisement
VERTICAL ID-100 CAMERA
Description
The Vertical ID-100 System is basically a standard ID-100 camera with the
Optical Assembly/Data Card Holder mounted in the vertical position (Refer to
Figure 1). The data card is inserted from the top. This produces a vertical ID
card with subject and data appearing one on top of the other instead of side-by-
side. To accommodate this change, some modifications were necessary.
Modifications
Note: All new part numbers are designated in the illustrations and in the table on
page 6.
Repositioning the Optical Assembly/Data Card holder resulted in the following
modifications:
1.
A new molded Front Shroud and extended Data Card Guide (Refer to
Figure 2).
Figure 1
2
ID-100 Manual Addendum
Data Card Slot
Optical Assembly/Data Card
Holder (vertically aligned)
Advertisement
