26. CONNECTING THE EXTERNAL PROBE
The wiring harness leaving the control board includes to RED wires fitted with faston covers. Connect the external probe
to these two wires.
With the external probe connected it is possible to change the curve "kt" (Graph 1) by means of the
"kt" curves
27. NOTES FOR INSTALLATIONS WITH SEPARATE OUTLETS
In special cases, installations with separate outlets can generate vibrations that may cause the fumes pressure switch to
trip (fault E03 on the boiler display).
To solve this problems, two slots closed with pre-punched holes (Ref. A and B) have been prepared on the fumes outlet.
These can be easily removed by the Qualified Technical Assistance Service without having to remove the outlet.
Remove knock-out A (Detail 1) and check the appliance works correctly.
If not, remove knock-out B (Detail 2) as well.
INSTRUCTIONS FOR FITTERS
TM
TM = Delivery temperature range
Te = External temperature
45
+/-
buttons.
Te
Chart 2
71.07144.01 - EN