GE JGRP20 Owner's Manual page 24

Before you call for service...
Troubleshooting Tips
Problem
Oven will not self-clean
"Crackling" or
"popping" sound
Excessive smoking
Oven door will not open
after a clean cycle
Oven not clean after a
clean cycle
"LOCK DOOR" flashes
in the display
LOCKED DOOR light
flashes in the display
letter flash in the display
Display goes blank
Display flashes
Unable to get the
display to show "SF"
24
Possible Causes What To Do
• Allow the oven to cool to room temperature and
reset the controls.
• Close door.
• See the Using the self-cleaning oven section.
• This is normal.
• Touch the CLEAR/OFF pad. Open the windows to
rid the room of smoke. Wait until the LOCKED DOOR
light goes off. Wipe up the excess soil and reset the
clean cycle.
• Allow the oven to cool below locking temperature.
• See the Using the self-cleaning oven section.
• Clean up heavy spillovers before starting the clean
cycle. Heavily soiled ovens may need to self-clean
again or for a longer period of time.
• Close the oven door.
• Touch the CLEAR/OFF pad. Allow the oven to cool.
• Touch the CLEAR/OFF pad. Allow the oven to cool for
one hour. Put the oven back into operation.
• Disconnect all power to the oven for 5 minutes
and then reconnect power. If the function error
code continues repeating, call for service.
• Replace the fuse or reset the circuit breaker.
• See the Special features of your oven control section.
• Reset the clock.
• The BAKE and BROIL HI/LO pads must be touched at
the same time and held for 2 seconds.