Mercury 2006 Mountaineer Owner's Manual page 86

Hide thumbs Also See for 2006 Mountaineer:
Table of Contents

Advertisement

Driver Controls
In the event of a multiple warning situation, the message center will cycle
the display to show all warnings by displaying each one for 4 seconds.
The message center will display the last selected feature if there are no
more warning messages. This allows you to use the full functionality of
the message center after you acknowledge the warning by pressing the
RESET control and clearing the warning message.
Warning messages are divided into four categories:
• They cannot be cleared until the condition is corrected.
• They will reappear on the display ten minutes from the reset if the
condition has not been corrected.
• They will not reappear until an ignition OFF-ON cycle has been
completed.
• They reappear if the condition clears then reoccurs within the same
ignition ON-OFF cycle.
This acts as a reminder that these warning conditions still exist within
the vehicle.
Warning display
Door ajar
Check charging system
Fuel level low
Park brake engaged
Check brake system
Check park aid (if equipped)
Low tire pressure
Tire monitor fault
Tire sensor fault
Brake fluid level low
Check headlamp
Check highbeam lamp
Check turn lamp
Washer fluid level low
Oil change required
Engine oil change soon
Liftgate/glass ajar
86
2006 Mountaineer (mnt)
Owners Guide (post-2002-fmt)
USA (fus)
Status
Warning cannot be reset
Warning returns after 10 minutes
Warning returns only after the ignition
key is turned from OFF to ON.
Warning returns after the condition
has cleared then reoccures within the
same ignition ON-OFF cycle.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents